bionstudio.blogg.se

Dimplex opti myst pro
Dimplex opti myst pro













dimplex opti myst pro

#DIMPLEX OPTI MYST PRO BLUETOOTH#

The tethered controller serves as the bluetooth receiver for communication with the remote, and must be connected for remote operation of the unit. Remote Control and Tethered Controller for CDFI500-PRO and CDFI1000-PRO Remote Control and Tethered Controller for CDFI1000P NOTE: The icons with 1 dot indicate controls for the primary and 2 dots indicate controls for the secondary. Remote Control and Tethered Controller for CDFI500P

dimplex opti myst pro

On the Remote and Tethered Controller: Pressing the will turn the volume On and Off.

dimplex opti myst pro

On the unit: Pressing the will decrease the volume and pressing the will increase the volume. NOTE: When the water tank is empty, the flame effect shuts OFF and the LED’s will blink.Īdjusts the volume of the wood fire sound effects. This will vary depending on ambient conditions and should be considered normal. NOTE: During normal operation it is expected to see some condensation of water on the media plate. NOTE: A few moments will be required between adjustment and a change to the flame effect. One beep will be heard when the flame height has reached the minimum or maximum level. Pressing the will decrease the flame effect and pressing the will increase the flame effect. Used for troubleshooting issues – outlined in the Test Mode section of this service manualĪdjusts the intensity of the flame and smoke effect when the unit has been activated. Required for synchronization of the remote, see synchronization instructions for more detail. Turns the operation of the flame effect on or off. NOTE: When the unit is first turned on the lights will come on and mist will appear 45 seconds later. The unit can be operated using any of the control options (onboard, tethered controller, or remote control). The unit will be in standby mode when it is first powered on. When the switch is set to the On position, the unit will emit one beep. NOTE: Always ensure that the appliance is fixed to the framing in a level position. This is normal and should not be a cause for concern. NOTE: When the unit is used in an environment where background noise is very low, it may be possible to hear a sound which is related to the operation of the flame effect. Finer adjustment can be done using the controls on the right module to have both modules operating at the same level (secondary). The primary side controls include the power switch and standby button, whereas the secondary side controls do not. The CDFI1000P and the CDFI1000-PRO units have two separate internal modules that are controlled by the settings entered on the left side (primary).















Dimplex opti myst pro